APRILIA RACING RSV4 TUONO TEFLON WASHER KIT FOR REAR LINKAGE This kit is compatible for the
and contains
|
19.90 €
*
In stock |
|
|
Old price 519.00 €
from
429.00 €
*
In stock |
Aprilia RSV4 1000/1100 Race generator kit 2009-2020 This is the complete race generator kit including the lightweight flywheel, stator, mounting plate, cup fasteners, connectors and specific regulator / rectifier |
from
1,079.00 €
*
In stock |
Batteriy Disconnect Switch 12 - 32 V 3 positions Recommended for all motorcycles with racing alternator. Comfortable and secure battery disconnection. protect the battery when bike is not in use from discharge. Switch has 3 setting position, removeable in Off-Setting. Needed whole cut for installation 29mm
|
22.90 €
*
In stock |
|
Adding too much fuel for the race, not only results in unnecessary higher vehicle weight, but also and more important in unnecessarily higher dynamic weight-shifting effects, which are produced by sloshing of the fuel in the tank (even when tank foam is used). Especially while braking and while changing direction, these forces have a negative effect on the handling and the dynamic balance suspension of your bike. This Fuel Draining Kit can be installed Plug & Play. Only high quality and selected and/or prefabricated components are used. One example is the acetal CPC coupling with FKM seal or the aramid reinforced FPM petrol hose. The old gasoline pipe comes in your spare part box and can be used for later rebuild. The supplied wiring harness contains isolated quick connectors for the fuel pump and the needed switched 12V-source. The hose trim on the tank needs to be reworked and also a 12mm hole need to be drilled for the pushbutton. The necessary milling head and the necessary 12mm conical drill are also included in this set. With this Plug & Play RSV4 Fuel Drain Kit, you can measure your consumption per lap in the training sessions. To do this, first drain the tank until pump starts to suck air. Then fill the tank with a certain amount of gasoline, e.g. 8 liters. After your training session, repeat the process. The difference divided by the number of laps results in your consumption per lap. For the race, you calculate in advance the rounds to be driven, including the inlap, pre-start, race laps and the outlap. Please add 1 to 1,5 liter to your calculated amount of liters. This reserve is used for your safety so that the gasoline pump does not sucks any air in high leaning angles or braking phases.
Can also be confectioned for other motorcycle models. please ask for your model. We will find a solution. Please take notice of the installation instructions and the maintenance advice. Parts List:
Advantages:
|
169.00 €
*
Currently unavailable |
APRILA RACING EMULATOR KIT EURO5 2021+
from 2021 with Euro 5 engine and includes the functions:
This product was designed by AndroidX and manufactured bei IRC. An english installation instruction will be provided. ATTENTION: Only for the racetrack, no ABE-no guarantee |
159.00 €
*
In stock |
|
APRILIA RACING RADIATOR CATCH TANK
and contains
|
57.50 €
*
In stock |
|
APRILIA RACING RSV4 TUONO AXLE PROTECTOR KIT
and contains
Milled from Polyoxymethylen (POM) plastic. POM is one of the typical engineering thermoplastics with good mechanical properties and high dimensional stability as well as excellent sliding and wear characteristics.
|
69.90 €
*
In stock |
|
APRILIA RACING RSV4 TUONO FRAME PROTECTION PADS
and contains
Milled from Polyoxymethylen (POM) plastic. POM is one of the typical engineering thermoplastics with good mechanical properties and high dimensional stability as well as excellent sliding and wear characteristics. ATTENTION: Only for the racetrack, no ABE-no guarantee |
Old price 269.90 €
229.90 €
*
In stock |
|
APRILIA RACING RSV4 TUONO SHIFT SHAFT SUPPORT
and contains
Made of high-strength aluminum, the shift shaft reinforcement stabilizes the shift shaft that stick out too far and thus prevents elastic twisting during fast and hard gear changes. This eliminates shift problems and protects your gear box. ATTENTION: Only for the racetrack, no ABE-no guarantee |
69.90 €
*
In stock |
|
APRILIA RACING RSV4 TUONO CNC SPROCKET COVER
and contains
Can be combined very well with the switching shaft reinforcement offered here. ATTENTION: Only for the racetrack, no ABE-no guarantee |
89.25 €
*
In stock |
|
APRILIA RACING RSV4 TUONO CNC SPROCKET COVER
and contains
|
79.90 €
*
Currently unavailable |
APRILIA RACING RSV4 TUONO CHAIN SUPPORT This kit is compatible for the
and contains
|
39.00 €
*
In stock |
|
NGK Iridium CR10EIX Stock No. 6482 Minimum order quantity: 4
NGK iridium spark plugs currently represent the highest quality technical solution. They have an iridium alloy on the center electrode, which is welded on in a special process with the help of a laser. The precious metal iridium is one of the hardest metals in the world. Its melting point is 2450 ° C and is therefore particularly resistant to spark erosion. By using this metal, the service life is doubled on average compared to conventional spark plugs made of nickel. ATTENTION: Please only ever use the spark plugs that are explicitly specified by your motorcycle manufacturer in the operating instructions or that have been clearly approved by the spark plug manufacturer for your model. Please check if this products fits your bike with NGK product finder, see link: Using the wrong spark plugs can damage your vehicle! |
14.90 €
*
In stock |
|