Adjustable Electric Water Pump Kit
Why have an electric water pump kit?
• Reduced drag on your engine (lost bhp)
• Only runs when needed
• High flow rate even at tickover
• 20L / min max flow rate
Why choose our kit over another kit?
• Start temperature is adjustable
• Max flow temperature is adjustable
• Targets maximum performance temperature (around 65C)
• Higher flow rate than Davies Craig / Bosch pump
• Lower current use than DC & Bosch too
• Small and light
• Negates the need for a stat
Essentially the kit replaces the mechanical water pump and conventional thermostat and controls engine water temperature itself.
It also means less drag on your engine as you can remove the original mechanical pump.
This kit will regulate the water temperature within a range you can set using the calibration pots.
The top of range can be adjusted between 55-65ºC and the bottom of range can be adjusted between 35-45ºC in between these values the pump increases in flow rate linearly.
Moving the calibration pots clockwise increases the temperature and anticlockwise decreases the temperature meaning you can set the desired range you want your water temperature to run at.
There are NO moving shafts and NO seals to wear out.
Maximum flow rate is 20 L/min!
Also, this kit runs at a speed totally independent of the engine speed, so even if the engine is left ticking over for a long time it will not overheat.
Tested to 20,000 hrs life.
The kit includes (524g):
• The electric water pump for hoses with 20mm diameter, 360g
• Temperature sensor with 1/8" x 27 NPTF tapered threads, 11g
• Rubber mounting bracket for electric water pump, 58g
• Wiring loom for electric water pump, 35g
• Controller for electric water pump
• All connectors which are always required
The temperature sensor should ideally be fitted into the head where the water will be hottest - the thread for the sensor is 1/8" x 27 NPTF tapered.
